TLC3574IDW Texas Instruments - Yeehing Electronics

14-bit, Serial Out, Low Power with Built-in Conversion Clock & 8x FIFO, 4 Channels

Pricing (USD)

Quantity	Unit Price
1 — 99	18.657
100 — 249	16.297
250 — 999	12.565
1,000 +	7.87

The above prices are for reference only.

Specifications

Manufacturer	Texas Instruments
Product Category	Analog to Digital Converters - ADC
RoHS	Y
Series	TLC3574
Mounting Style	SMD/SMT
Package / Case	SOIC-20
Resolution	14 bit
Number of Channels	4 Channel
Sampling Rate	200 kS/s
Input Type	Pseudo-Differential/Single-Ended
Interface Type	3-Wire, SPI
Architecture	SAR
Reference Type	External
Analog Supply Voltage	4.75 V to 5.5 V
Digital Supply Voltage	2.7 V to 5.5 V
SNR - Signal to Noise Ratio	80 dB
Minimum Operating Temperature	- 40 C
Maximum Operating Temperature	+ 85 C
Packaging	Tube
Features	Oscillator
Height	2.35 mm
Length	12.8 mm
Number of Converters	1 Converter
Power Consumption	29 mW
Width	7.52 mm
Brand	Texas Instruments
Development Kit	TLC3574EVM
DNL - Differential Nonlinearity	+/- 1 LSB
INL - Integral Nonlinearity	+/- 1.5 LSB
Operating Supply Voltage	5 V
Product Type	ADCs - Analog to Digital Converters
SINAD - Signal to Noise and Distortion Ratio	79 dB
Factory Pack Quantity	25
Subcategory	Data Converter ICs
Unit Weight	0.018953 oz

For more information, please refer to datasheet

Documents

TLC3574IDW Datasheet

More Information

The TLC3574, TLC3578, TLC2574, and TLC2578 are a family of high-performance, low-power, CMOS analog-to-digital converters (ADC). TLC3574/78 is a 14-bit ADC; TLC2574/78 is a 12-bit ADC. All parts operate from single 5-V analog power supply and 3-V to 5-V digital supply. The serial interface consists of four digital input [chip select (CS), frame sync (FS), serial input-output clock (SCLK), serial data input (SDI)], and a 3-state serial data output (SDO). CS (works as SS, slave select), SDI, SDO and SCLK form an SPI interface. FS, SDI, SDO, and SCLK form DSP interface. The frame sync signal (FS) indicates the start of a serial data frame being transferred. When multiple converters connect to one serial port of a DSP, CS works as the chip select to allow the host DSP to access the individual converter. CS can be tied to ground if only one converter is used. FS must be tied to DVDD if it is not used (such as in an SPI interface). When SDI is tied to DVDD, the device is set in hardware default mode after power on and no software configuration is required. In the simplest case, only three wires (SDO, SCLK, and CS or FS) are needed to interface with the host.